2GR-FE Engine control system

Removal

9steps
~54min
2/5difficulty
Done 0 of 9

1. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

2. REMOVE FRONT OUTER COWL TOP PANEL SUBASSEMBLY

3. DRAIN ENGINE COOLANT

4. REMOVE V-BANK COVER SUB-ASSEMBLY

5. REMOVE NO. 2 AIR CLEANER INLET

6. REMOVE NO. 1 AIR CLEANER INLET

7. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

  1. Disconnect the 3 vacuum hoses.
    REMOVE AIR CLEANER CAP SUB-ASSEMBLY
  2. Remove the No. 2 ventilation hose and air cleaner hose band.
  3. Disconnect the vacuum hose (EVAP) from the air cleaner hose.
    REMOVE AIR CLEANER CAP SUB-ASSEMBLY
  4. Disconnect the mass air flow meter connector.
  5. Remove the 2 bolts and air cleaner cap subassembly.

8. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

REMOVE AIR CLEANER CASE SUB-ASSEMBLY

9. REMOVE THROTTLE BODY

REMOVE THROTTLE BODY
  1. Disconnect the throttle body connector and clamp.
    REMOVE THROTTLE BODY
  2. Disconnect the 2 water by-pass hoses from the throttle body.
    REMOVE THROTTLE BODY
  3. Remove the 4 bolts and throttle body.
  4. Remove the throttle body gasket from the intake air surge tank.

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.