Toyota Sienna Quiz
2GR-FE Engine control system

Installation

In this manual: 2GR-FE Engine control system
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
3steps
~18min
2/5difficulty
Done 0 of 3

1. INSTALL CRANKSHAFT POSITION SENSOR

INSTALL CRANKSHAFT POSITION SENSOR
  1. Apply a light coat of engine oil to the O-ring on the crankshaft position sensor.
  2. Install the crankshaft position sensor with the bolt.

    Torque: 9.0 N*m (92 kgf*cm, 80 in.*lbf)

  3. Connect the crankshaft position sensor connector.

2. INSTALL COMPRESSOR AND MAGNETIC CLUTCH

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.