Toyota Sienna Quiz
Exterior

Installation

In this manual: Exterior
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
10steps
~60min
3/5difficulty
Done 0 of 10

1. INSTALL OUTSIDE MOULDING

  1. Using a heat light, heat the mounting surface of the vehicle body between 40 to 60 C (104 to 140 F).

    NOTICE: Do not heat the body excessively.

  2. Remove the tape from the vehicle body.
  3. Wipe off the stains with cleaner.
  4. Clean the outside moulding (if reusing the outside moulding)
  5. Using a heat light, heat the outside moulding between 20 to 30 C (68 to 86 F).

NOTICE: Do not heat the outside moulding excessively.

  1. Remove the tape from the outside moulding.
  2. Wipe off the stains with cleaner.
  3. Apply new tape to the outside moulding as shown in the illustration.
    INSTALL OUTSIDE MOULDING
  4. Match the reference pins on the outside moulding with the reference holes on the vehicle body.
  5. Using a heat light, heat the vehicle body and outside moulding.

Heating temperature:

Heating temperature

NOTICE: Do not heat the body and outside moulding excessively.

  1. Release the peeling paper from the face of the outside moulding and attach the outside moulding securely to the vehicle body.

NOTICE: Be careful that dirt or foreign objects do not stick to adhesive part when releasing the peeling paper.

  1. Push the outside moulding to the body.

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.