Toyota Sienna Quiz
Sliding roof

Installation

In this manual: Sliding roof
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
3steps
~18min
2/5difficulty
Done 0 of 3

1. INSTALL SLIDING ROOF HOUSING ASSEMBLY

  1. Install the housing with the 6 nuts.
  2. Install the 4 brackets with the 8 bolts.
  3. Connect the 4 hoses and drive gear connector.

2. ADJUST SLIDING ROOF GLASS SUB-ASSEMBLY

ADJUST SLIDING ROOF GLASS SUB-ASSEMBLY
  1. Check for a difference in levels between the sliding roof (roof glass) and roof panel.

Difference: 0 +- 2.0 mm (0.072 in.)

NOTICE: The clearance should be even all around

3. INSTALL SLIDING ROOF GLASS SUB-ASSEMBLY

  1. Using a torx wrench T25, loosen the screw to adjust the sliding roof panel position. When the adjustment has been done, tighten the screw there.

4. RESET SLIDING ROOF POSITION

5. CHECK FOR WATER LEAKS

  1. Adjusting the sliding roof, check that there is no water leak.

    If a leak is found, readjust the sliding roof.

6. INSTALL ROOF HEADLINING ASSEMBLY

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.