Installation

1. INSTALL PARK/NEUTRAL POSITION SWITCH ASSEMBLY

(a) Install the park/neutral position switch to the manual valve shaft.

(b) Temporarily install the 2 bolts.

(c) Place a new lock plate and tighten the nut.

Torque: 6.9 N*m (70 kgf*cm, 61 in.*lbf) (d) Temporarily install the control shaft lever.

(e) Turn the lever counterclockwise until it stops, then turn it clockwise 2 notches.

(f) Remove the control shaft lever.

(g) Align the groove with the neutral basic line.

(h) Hold the switch in position and tighten the 2 bolts.

Torque: 5.4 N*m (55 kgf*cm, 48 in.*lbf)

(i) Using a screwdriver, bend the tabs of the lock plate.

(j) Install the control shaft lever, washer and the nut.

Torque: 13 N*m (130 kgf*cm, 9 ft.*lbf)

(k) Connect the park/neutral position switch connector

2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

(a) Connect the control cable to the control shaft lever with the nut.

Torque: 13 N*m (133 kgf*cm, 10 ft.*lbf)

(b) Install the control cable with a new clip to the bracket.

3. ADJUST PARK/NEUTRAL POSITION SWITCH ASSEMBLY (See page AX-127)

4. INSPECT PARK/NEUTRAL POSITION SWITCH ASSEMBLY OPERATION (See page AX-126)

5. INSPECT SHIFT LEVER POSITION (See page AX-148)

6. ADJUST SHIFT LEVER POSITION (See page AX-149)

7. INSTALL AIR CLEANER ASSEMBLY

HINT: (See page EM-44)

8. INSTALL BATTERY