Park assist / monitoring
Rear Clearance Sonar Sensor LH Circuit
In this manual: Park assist / monitoring
5steps
~30min
2/5difficulty
Done 0 of 5
DESCRIPTION
An ultrasonic sensor consists of a sensor portion that transmits and receives ultrasonic waves and a preamplifier that amplifies them. The ultrasonic sensor outputs the ultrasonic waves and sends the received signals to the clearance warning ECU.
WIRING DIAGRAM

INSPECTION PROCEDURE
1 INSPECT NO. 1 ULTRASONIC SENSOR

- Remove the No. 1 ultrasonic sensor.
- Measure the resistance according to the value(s) in the table below.
Standard resistance

2 CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - NO. 1 ULTRASONIC SENSOR)

- Disconnect the C9 connector from the clearance warning ECU.

- Disconnect the U4 connector from the No. 1 ultrasonic sensor.
- Measure the resistance according to the value(s) in the table below.
Standard resistance

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
Test yourself
A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?