Toyota Sienna Quiz
Wiper and washer

Rear wiper rubber

In this manual: Wiper and washer
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
2steps
~12min
1/5difficulty
Done 0 of 2

COMPONENTS

COMPONENTS

REMOVAL

1. REMOVE REAR WIPER BLADE ASSEMBLY

REMOVE REAR WIPER BLADE ASSEMBLY
  1. Remove the rear wiper arm head cap from the rear wiper arm.
  2. Raise the rear wiper blade to the position as shown in the illustration where the meshing of the claw is disengaged with the click sound.
NOTICE: Be careful not to break the claw.
  • Pull the rear wiper blade straight from the wiper arm toward the left side of the vehicle.

    • NOTICE: Do not fold the rear wiper arm with the rear wiper blade being removed from it.

    2. REMOVE REAR WIPER RUBBER

    REMOVE REAR WIPER RUBBER
    1. Pull the end of the rubber protruded from the blade stopper as shown in the illustration.

    NOTICE: Do not pull out the wiper rubber forcibly.

    Otherwise, the backing plates are deformed or blade claw is damaged. HINT: Pushing the position close to the middle of the blade raises the rubber, making easier to pull the rubber out.

    INSTALLATION

    1. INSTALL REAR WIPER RUBBER

    INSTALL REAR WIPER RUBBER
    1. Install the 2 wiper rubber backing plates to the rear wiper rubber.

    NOTICE: Be sure to install the wiper rubber backing plates in the right direction.

    Test yourself

    A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.