Reassembly

1. INSTALL FRONT AXLE HUB LH BEARING

(a) Using SST(s) and a press, install a new front axle hub LH bearing to the steering knuckle LH.

SST 09950-60020 (09951-00810), 09950-70010 (09951-07100)

2. INSTALL DISC BRAKE DUST COVER FRONT LH

(a) Place the disc brake dust cover front LH and using a torx wrench (T30), torque the 4 bolts.

Torque: 8.3 N*m (85 kgf*cm, 74 in.*lbf)

HINT: Torx is a registered trademark of Textron Inc.

3. INSTALL FRONT AXLE HUB SUB-ASSEMBLY LH

(a) Using SST(s), and a press, install the front axle hub sub-assembly LH.

SST 09608-32010, 09950-60020 (09951-00810), 09950-70010 (09951-07100)

4. INSTALL FRONT AXLE HUB LH HOLE SNAP RING

(a) Using snap ring pliers, install a new front axle hub LH hole snap ring.

5. INSTALL FRONT WHEEL BEARING DUST DEFLECTOR NO.1 LH

(a) Using SST(s) and a hammer, install the bearing dust deflector No. 1 LH.

SST 09316-60011 (09316-00011, 09316-00031), 09608-32010

HINT: Align the hole for the speed sensor in the bearing dust deflector No. 1 LH with the steering knuckle.

6. INSTALL LOWER BALL JOINT ASSEMBLY FRONT LH

(a) Install the lower ball joint assembly front LH and tighten the nut.

Torque: 123 N*m (1,250 kgf*cm, 91 ft.*lbf) (b) Install a new cotter pin.

NOTICE: If the holes for the cotter pin are not aligned, tighten the nut up to 60° further.