Toyota Sienna Quiz
Supplemental restraint system

Removal

In this manual: Supplemental restraint system
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
2steps
~12min
1/5difficulty
Done 0 of 2

HINT:

  • Use the same procedures for the RH side and LH side.
  • The procedures listed below are for the LH side.

1. PRECAUTION

CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

3. REMOVE STEERING PAD

4. REMOVE STEERING WHEEL ASSEMBLY

5. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY

6. REMOVE ROOF HEADLINING ASSEMBLY

HINT: Refer to the procedures up to "REMOVE ROOF HEADLINING ASSEMBLY".

7. REMOVE POWER BACK DOOR UNIT ASSEMBLY

REMOVE POWER BACK DOOR UNIT ASSEMBLY
  1. Remove the 3 bolts and the power back door unit assembly.
  2. When replacing the RH side follow the procedure below.

    Remove the air duct rear No. 6.

8. REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH
  1. Disconnect the connector from the curtain shield airbag assembly LH.
NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.
  • Remove the clip.
  • Remove the 13 bolts and the curtain shield airbag assembly LH in the order shown in the illustration.
    • REMOVE CURTAIN SHIELD AIRBAG ASSEMBLY LH

    Test yourself

    A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.