Removal

1. DISCHARGE FUEL SYSTEM PRESSURE

2. REMOVE V-BANK COVER SUB-ASSEMBLY

3. DRAIN ENGINE COOLANT

4. REMOVE WINDSHIELD WIPER MOTOR ASSEMBLY

5. REMOVE FRONT OUTER COWL TOP PANEL SUBASSEMBLY

6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

7. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

8. REMOVE INTAKE AIR SURGE TANK ASSEMBLY

1. 1
   Disconnect the 2 water by-pass hoses from the throttle body [A].
2. 2
   Disconnect the vapor feed hose [B].
3. 3
   Disconnect the throttle body connector and clamp [C].

   

4. 4
   Disconnect the ventilation hose [D].
5. 5
   Disconnect the union to check valve hose [E].

   

6. 6
   Disconnect the connector [F].

   

7. 7
   Using a 5 mm socket hexagon wrench, remove the 4 bolts [G].
8. 8
   Remove the 2 nuts, 2 bolts and intake air surge tank [H].
9. 9
   Remove the gasket from the intake air surge tank [I].

9. REMOVE FUEL MAIN TUBE SUB-ASSEMBLY

10. REMOVE INTAKE MANIFOLD

11. REMOVE KNOCK CONTROL SENSOR

1. 1
   Disconnect the 2 knock sensor connectors.
2. 2
   Remove the 2 bolts and then remove the 2 knock control sensors.