Toyota Sienna Quiz
Supplemental restraint system

Removal

In this manual: Supplemental restraint system
Introduction — 55Service specifications — 7Maintenance — 7Engine — 264U151e automatic transaxle — 108Transfer — 19Propeller shaft — 8Drive shaft — 14Differential — 16Axle — 18Suspension — 37Tire and wheel — 54Brake control — 141Parking brake — 16Steering Column — 11Power steering — 18Air conditioning — 106Supplemental restraint system — 146Seat belt — 22Theft deterrent — 14Engine immobiliser — 17Cruise control — 65Lighting — 61Wiper and washer — 13Door lock — 42Meter — 28Audio / visual — 94Navigation — 108Park assist / monitoring — 33Horn — 5Garage door opener — 42GR-FE Engine control system — 126Supplemental restraint system — 147Other system — 14Windshield / windowglass — 43Mirror — 23Instrument panel — 6Seat belt — 22Seat — 92Engine hood / door — 104Exterior — 39Interior — 5Sliding roof — 9Multiplex communication — 18Can communication — 23
3steps
~18min
2/5difficulty
Done 0 of 3

1. PRECAUTION

CAUTION: Be sure to read "PRECAUTION" thoroughly before servicing.

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION: Wait for 90 seconds after disconnecting the cable to prevent the airbag working.

3. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

4. REMOVE STEERING WHEEL NO.3 COVER LOWER

5. REMOVE STEERING WHEEL NO.2 COVER LOWER

6. REMOVE STEERING PAD

7. REMOVE STEERING WHEEL ASSEMBLY

8. REMOVE STEERING COLUMN COVER

9. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY

10. REMOVE INSTRUMENT PANEL BOX NO.2

11. DISCONNECT FRONT PASSENGER AIRBAG ASSEMBLY CONNECTOR

DISCONNECT FRONT PASSENGER AIRBAG ASSEMBLY CONNECTOR
  1. Disconnect the connector from the front passenger airbag assembly.

NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.

12. REMOVE INSTRUMENT PANEL SUB-ASSEMBLY

13. REMOVE FRONT PASSENGER AIRBAG ASSEMBLY

REMOVE FRONT PASSENGER AIRBAG ASSEMBLY
  1. Remove the 2 screws.
    REMOVE FRONT PASSENGER AIRBAG ASSEMBLY
  2. Release the front side wall of the airbag door from the hook by slightly deflecting it and roll the front passenger airbag assembly rearward.
  3. Release the rear side wall of the airbag door from the other hook and remove the front passenger airbag assembly.

Test yourself

A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.