Mirror
Terminals of ECU
In this manual: Mirror
8steps
~48min
2/5difficulty
Done 0 of 8
1. CHECK OUTER MIRROR CONTROL ECU LH

- Disconnect the O9 and O10 connectors.
- Measure the voltage and resistance according to the value(s) in the table below.
Voltage

Resistance

If the result is not as specified, there may be a malfunction on the wire harness side.
- Reconnect the O9 and O10 connectors.
- Measure the voltage according to the value(s) in the table below
Voltage


If the result is not as specified, there may be a malfunction on the ECU side.
2. CHECK OUTER MIRROR CONTROL ECU RH

- Disconnect the O11 and O12 connectors.
- Measure the voltage and resistance according to the value(s) in the table below.
Voltage

Resistance

If the result is not as specified, there may be a malfunction on the wire harness side.
- Reconnect the O11 and O12 connectors.
- Measure the voltage according to the value(s) in the table below.
Voltage

If the result is not as specified, there may be a malfunction on the ECU side.
Test yourself
A quick Toyota Sienna quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?