Installation

1. INSTALL DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL

(a) Using SST and a hammer, install a new oil seal.

SST: 09554-30011

(b) Coat the oil seal lip with MP grease.

2. INSTALL FRONT DRIVE SHAFT ASSEMBLY LH

Click here

3. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

4. INSTALL FRONT SUSPENSION LOWER ARM LH

Click here

5. INSTALL FRONT SUSPENSION LOWER ARM RH

HINT:

Use the same procedure as for the LH side.

6. INSTALL TIE ROD END SUB-ASSEMBLY LH

Click here

7. INSTALL TIE ROD END SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

8. INSTALL FRONT SPEED SENSOR LH

Click here

9. INSTALL FRONT SPEED SENSOR RH

HINT:

Use the same procedure as for the LH side.

10. INSTALL FRONT STABILIZER LINK ASSEMBLY LH

Click here

11. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

12. INSTALL FRONT AXLE SHAFT LH NUT

Click here

13. INSTALL FRONT AXLE SHAFT RH NUT

HINT:

Use the same procedure as for the LH side.

14. ADD DIFFERENTIAL OIL

Click here

15. INSPECT DIFFERENTIAL OIL

Click here

16. INSTALL NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

Torque:

30 N·m {306 kgf·cm, 22 ft·lbf}

17. INSTALL NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Engine Under Cover No, 2)

Torque:

30 N·m {306 kgf·cm, 22 ft·lbf}

18. INSTALL FRONT WHEELS

Torque:

113 N·m {1152 kgf·cm, 83 ft·lbf}

19. INSPECT AND ADJUST FRONT WHEEL ALIGNMENT

Click here

20. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:

5,4 N·m {55 kgf·cm, 48 in·lbf}

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

21. CHECK VSC SENSOR SIGNAL (for Hydraulic Brake Booster)

Click here

22. CHECK VSC SENSOR SIGNAL (for Vacuum Brake Booster)

Click here