Removal

1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

3. REMOVE FRONT WHEELS

4. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

5. REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Engine Under Cover No, 2)

6. DRAIN DIFFERENTIAL OIL

7. REMOVE FRONT AXLE SHAFT LH NUT

Click here

8. REMOVE FRONT AXLE SHAFT RH NUT

HINT:

Use the same procedure as for the LH side.

9. SEPARATE FRONT STABILIZER LINK ASSEMBLY LH

Click here

10. SEPARATE FRONT STABILIZER LINK ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

11. SEPARATE FRONT SPEED SENSOR LH

Click here

12. SEPARATE FRONT SPEED SENSOR RH

HINT:

Use the same procedure as for the LH side.

13. SEPARATE TIE ROD END SUB-ASSEMBLY LH

Click here

14. SEPARATE TIE ROD END SUB-ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

15. SEPARATE FRONT SUSPENSION LOWER ARM LH

Click here

16. SEPARATE FRONT SUSPENSION LOWER ARM RH

HINT:

Use the same procedure as for the LH side.

17. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH

Click here

18. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.

19. REMOVE DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL

(a) Using SST, remove the oil seal. SST: 09308-00010