Installation

1. INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY

(a) Connect the airbag connector. NOTICE: When handling the airbag connector, take care not to damage the airbag wire harness.

(b) Push in the airbag connector lock to install the airbag connector.

(c) Install the lower No. 1 instrument panel airbag assembly with the 4 bolts.

Torque:

10 N·m {102 kgf·cm, 7 ft·lbf}

2. INSTALL INSTRUMENT PANEL LOWER FINISH PANEL SUB-ASSEMBLY LH

3. CONNECT HOOD LOCK CONTROL LEVER SUB-ASSEMBLY

4. INSTALL COWL SIDE TRIM BOARD LH

5. INSTALL FRONT DOOR SCUFF PLATE LH

6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:

5,4 N·m {55 kgf·cm, 48 in·lbf}

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here

7. INSPECT SRS WARNING LIGHT

Click here