Parking Brake Cable

Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE

1. DISCONNECT NO. 2 PARKING BRAKE SHOE ASSEMBLY WITH PARKING BRAKE SHOE LEVER

(See page )

2. REMOVE VOLTAGE INVERTER ASSEMBLY

(See page )

3. REMOVE NO. 2 PARKING BRAKE CABLE ASSEMBLY

(a) Loosen the adjusting nut.

(b) Disengage the 2 claws to remove the parking cable end stopper.

(c) Disconnect the No. 2 parking brake cable assembly from the No. 1 parking brake pull rod.

(d) Disengage the 3 claws of the No. 2 parking brake cable assembly and push the No. 2 parking brake cable assembly outside of vehicle slightly.

(e) Remove the 2 bolts and disconnect the No. 2 parking brake cable assembly from the backing plate.

(f) Remove the 4 bolts and No. 2 parking brake cable assembly.

4. REMOVE NO. 3 PARKING BRAKE CABLE ASSEMBLY

(a) Loosen the adjusting nut.

(b) Disengage the 2 claws to remove the parking cable end stopper.

(c) Disconnect the No. 3 parking brake cable assembly from the No. 1 parking brake pull rod.

(d) Disengage the 3 claws of the No. 3 parking brake cable assembly and push the No. 3 parking brake cable assembly outside of vehicle slightly.

(e) Remove the 2 bolts and disconnect the No. 3 parking brake cable assembly from the backing plate.

(f) Remove the 4 bolts and No. 3 parking brake cable assembly.

Installation INSTALLATION PROCEDURE

1. INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY

(a) Install the No. 3 parking cable assembly with the 4 bolts.

Torque:

13 N·m {127 kgf·cm, 9 ft·lbf}

(b) Attach the claws of the No. 3 parking brake cable assembly.

(c) Connect the No. 3 parking brake cable assembly to the No. 1 parking brake pull rod.

(d) Engage the 2 claws to install the parking brake cable end stopper.

(e) Install the No. 3 parking brake cable assembly to the backing plate with the 2 bolts.

Torque:

8 N·m {82 kgf·cm, 71 in·lbf}

2. INSTALL NO. 2 PARKING BRAKE CABLE ASSEMBLY

(a) Install the No. 2 parking brake cable assembly with the 4 bolts.

Torque:

13 N·m {127 kgf·cm, 9 ft·lbf}

(b) Attach the claws of the No. 2 parking brake cable assembly.

(c) Connect the No. 2 parking brake cable assembly to the No. 1 parking brake pull rod.

(d) Engage the 2 claws to install the parking brake cable end stopper.

(e) Install the No. 2 parking brake cable assembly to the backing plate with the 2 bolts.

Torque:

8 N·m {82 kgf·cm, 71 in·lbf}

3. CONNECT NO. 2 PARKING BRAKE SHOE ASSEMBLY WITH PARKING BRAKE SHOE LEVER

(See page )

4. INSPECT PARKING BRAKE LEVER TRAVEL

5. ADJUST PARKING BRAKE LEVER TRAVEL

6. INSTALL VOLTAGE INVERTER ASSEMBLY

(See page )

7. INSTALL REAR WHEEL

Torque:

113 N·m {1152 kgf·cm, 83 ft·lbf}