Parking Brake Switch

Components COMPONENTS ILLUSTRATION Inspection INSPECTION PROCEDURE

1. INSPECT PARKING BRAKE SWITCH ASSEMBLY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Text in Illustration

	On
	Off

Standard Resistance:

Tester Connection	Switch Condition	Specified Condition
Switch connector terminal - Switch body	On (Shaft not pressed)	Below 1 Ω
	Off (Shaft pressed)	10 kΩ or higher

If the result is not as specified, replace the parking brake switch assembly.

Installation INSTALLATION PROCEDURE

1. INSTALL PARKING BRAKE SWITCH ASSEMBLY

(a) Connect the connector to the parking brake switch assembly.

(b) Install the parking brake switch assembly to the parking brake lever with the screw.

Torque:

0,9 N·m {9 kgf·cm, 8 in·lbf}

2. INSTALL REAR CONSOLE BOX ASSEMBLY

(See page )

Removal REMOVAL PROCEDURE

1. REMOVE REAR CONSOLE BOX ASSEMBLY

(See page )

2. REMOVE PARKING BRAKE SWITCH ASSEMBLY

(a) Remove the screw and parking brake switch assembly from the parking brake lever.

(b) Disconnect the connector.