Ptc Heater Assembly

1. REMOVE LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

(See page )

2. REMOVE INSTRUMENT LOWER PANEL ASSEMBLY

3. REMOVE AIR DUCT ASSEMBLY

4. REMOVE QUICK HEATER ASSEMBLY

(a) Disconnect the connector.

(b) Remove the 2 screws and quick heater assembly.

1. INSPECT QUICK HEATER ASSEMBLY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below. Text in Illustration *a Component without harness connected (Quick Heater Assembly) Standard Resistance: Tester Connection (Terminal Code) Switch Condition Specified Condition 1(B) - 2(E) Always Below 1 Ω 3(B) - 2(E) Always Below 1 Ω 3(B) - 4(E) Always Below 1 Ω 5(B) - 4(E) Always Below 1 Ω If the specified condition is not met, replace the quick heater assembly.

1. INSTALL QUICK HEATER ASSEMBLY

(a) Install the quick heater assembly with the 2 screws.

(b) Connect the connector.

2. INSTALL AIR DUCT ASSEMBLY

3. INSTALL INSTRUMENT LOWER PANEL ASSEMBLY

4. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY

(See page )