Reassembly

REASSEMBLY PROCEDURE

1. INSTALL REAR BUMPER SIDE STAY LH

(a) Install the rear bumper side stay LH with the 2 bolts. Torque: 30 N·m {306 kgf·cm, 22 ft·lbf}

2. INSTALL REAR BUMPER SIDE STAY RH

HINT:

Use the same procedure as for the LH side.

3. INSTALL NO. 6 FLOOR WIRE

(a) Engage the wire harness clamps to install the No. 6 floor wire. Text in Illustration *1 Adhesive Tape

(b) Install 2 new adhesive tapes.

4. INSTALL BLIND SPOT MONITOR SENSOR LH (w/ Blind Spot Monitor)

(a) Install the blind spot monitor sensor LH with the 3 nuts. Torque: 9 N·m {92 kgf·cm, 80 in·lbf}

(b) Connect the connector.

5. INSTALL BLIND SPOT MONITOR SENSOR RH (w/ Blind Spot Monitor)

HINT:

Use the same procedure as for the LH side.

6. INSTALL NO. 1 ULTRASONIC SENSOR (w/ Clearance Sonar System)

7. INSTALL REAR BUMPER EXTENSION LH

(a) w/ Clearance Sonar System:

(1) Connect the connector. Text in Illustration *a Clamp

(b) Install the rear bumper extension LH.

(c) Install the clamp.

(d) Install the 5 clips.

8. INSTALL REAR BUMPER EXTENSION RH

HINT:

Use the same procedure as for the LH side.

9. INSTALL REAR BUMPER PLATE

(a) Engage the 6 guides to install the rear bumper plate.

Text in Illustration

*a

Wire Harness Clamp

*b

Guide

(b) Install the 10 bolts.

Torque:

30 N·m {306 kgf·cm, 22 ft·lbf}

(c) Engage the wire harness clamps.

10. INSTALL NO. 1 ULTRASONIC SENSOR (w/ Clearance Sonar System)

11. INSTALL REAR BUMPER PAD SUB-ASSEMBLY

(a) Engage the 2 claws to install the license plate light lens. HINT: Use the same procedure for the RH side and LH side.

(b) w/ Clearance Sonar System:

(1) Connect the 2 connectors.

(2) Engage the 14 claws to install the rear bumper pad sub-assembly.

(3) Install the 3 clips.

(c) w/o Clearance Sonar System:

(1) Engage the 14 claws to install the rear bumper pad sub-assembly.

(2) Install the 3 clips.

(d) Connect the connector to install the license plate light. HINT: Use the same procedure for the RH side and LH side.

(e) Install the 2 license plate light assemblies.

12. INSTALL REAR BUMPER HOLE COVER

(a) Engage the 2 claws to install the rear bumper hole cover.