Toyota Tacoma Quiz
Tire And Wheel

Receiver Error (C2176/76)

In this manual: Tire And Wheel
Introduction — 15Maintenance — 8Audio / Video — 94Garage Door Opener — 7Navigation / Multi Info Display — 84Park Assist / Monitoring — 86Brake — 50Brake Control / Dynamic Control Systems — 165Parking Brake — 52gr-fks Charging — 252gr-fks Cooling — 212gr-fks Emission Control — 132gr-fks Engine Control — 322gr-fks Engine Mechanical — 332gr-fks Exhaust — 92gr-fks Fuel — 422gr-fks Ignition — 62gr-fks Intake — 72gr-fks Lubrication — 152gr-fks Starting — 38Ac60e Automatic Transmission / Transaxle — 146Axle — 19Clutch — 20Cruise Control — 168Differential — 50Drive Shaft — 6Propeller Shaft — 23Rc62f Manual Transmission / Transaxle — 34Suspension — 22Tire And Wheel — 39Vf2cm Transfer — 44Can Communication — 45Multiplex Communication — 20Power Distribution — 5Power Steering — 29Steering Column — 29Air Conditioning — 108Door Lock — 88Engine Hood / Door — 16Engine Immobiliser — 47Exterior — 55Horn — 5Interior — 18Interior Panel — 8Lighting — 93Meter / Gauge / Display — 31Mirror — 22Other System — 24Pre-collision — 40Seat — 52Seat Belt — 40Sliding Roof — 26Supplemental Restraint Systems — 139Theft Deterrent — 20Window / Glass — 53Wiper / Washer — 24
~1min read
DESCRIPTION

Tire pressure warning valve and transmitter signals are transmitted to the tire pressure warning ECU and receiver in the vehicle as radio waves.

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

Note

C2176/76

Receiver Error

Malfunction in the tire pressure warning ECU and receiver internal circuit

Tire pressure warning ECU and receiver

-
CAUTION / NOTICE / HINT

NOTICE:

  • When replacing the tire pressure warning ECU and receiver, read the transmitter IDs stored in the old ECU using the Techstream and write them down before removal.
  • It is necessary to perform initialization (See page ) of the transmitter IDs into the tire ) after registration (See page pressure warning ECU and receiver if the ECU has been replaced. ) of the transmitter IDs into the tire pressure warning ECU and receiver if the ECU has been replaced.
PROCEDURE

  1. CHECK AND REPLACE DTC OUTPUT (C2176/76)

(a) Clear the DTCs (See page (b) Turn the ignition switch off. ).

(b) Turn the ignition switch off.

(c) Turn the ignition switch to ON and check for DTCs (See page OK: ).

OK:

DTC C2176/76 is not output.

OK

END
NG

REPLACE TIRE PRESSURE WARNING ECU AND RECEIVER

Test yourself

A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.