Toyota Tacoma Quiz
Vf2cm Transfer

Transfer Case Rear Oil Seal

In this manual: Vf2cm Transfer
Introduction — 15Maintenance — 8Audio / Video — 94Garage Door Opener — 7Navigation / Multi Info Display — 84Park Assist / Monitoring — 86Brake — 50Brake Control / Dynamic Control Systems — 165Parking Brake — 52gr-fks Charging — 252gr-fks Cooling — 212gr-fks Emission Control — 132gr-fks Engine Control — 322gr-fks Engine Mechanical — 332gr-fks Exhaust — 92gr-fks Fuel — 422gr-fks Ignition — 62gr-fks Intake — 72gr-fks Lubrication — 152gr-fks Starting — 38Ac60e Automatic Transmission / Transaxle — 146Axle — 19Clutch — 20Cruise Control — 168Differential — 50Drive Shaft — 6Propeller Shaft — 23Rc62f Manual Transmission / Transaxle — 34Suspension — 22Tire And Wheel — 39Vf2cm Transfer — 44Can Communication — 45Multiplex Communication — 20Power Distribution — 5Power Steering — 29Steering Column — 29Air Conditioning — 108Door Lock — 88Engine Hood / Door — 16Engine Immobiliser — 47Exterior — 55Horn — 5Interior — 18Interior Panel — 8Lighting — 93Meter / Gauge / Display — 31Mirror — 22Other System — 24Pre-collision — 40Seat — 52Seat Belt — 40Sliding Roof — 26Supplemental Restraint Systems — 139Theft Deterrent — 20Window / Glass — 53Wiper / Washer — 24
~1min read
6special tools
Components COMPONENTS ILLUSTRATION Replacement Replacement REPLACEMENT PROCEDURE

1. DRAIN TRANSFER OIL

2. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

2. REMOVE PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

(See page 3. REMOVE OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY )

3. REMOVE OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY

4. REMOVE TRANSFER EXTENSION HOUSING TYPE T OIL SEAL

4. REMOVE TRANSFER EXTENSION HOUSING TYPE T OIL SEAL

(a) Using SST, remove the transfer extension housing type T oil seal.

SST: 09308-00010

NOTICE:

Be careful not to damage the transfer extension housing type T oil seal and extension housing contact surface.

5. INSTALL TRANSFER EXTENSION HOUSING TYPE T OIL SEAL

(a) Coat the lip of a new transfer extension housing type T oil seal with MP grease.

(b) Using SST and a hammer, install the transfer extension housing type T oil seal as shown in the illustration.

SST: 09631-12090

SST: 09950-60010

09951-00600

SST: 09950-70010

09951-07100

Drive in depth (A):

48.5 to 49.5 mm (1.910 to 1.948 in.)

NOTICE:

Be careful not to damage the transfer extension housing type T oil seal.

6. INSTALL OUTPUT SHAFT COMPANION FLANGE SUB-ASSEMBLY

7. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

7. INSTALL PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY

(See page 8. ADD TRANSFER OIL )

8. ADD TRANSFER OIL

9. CHECK FOR TRANSFER OIL LEAK

9. CHECK FOR TRANSFER OIL LEAK

Test yourself

A quick Toyota Tacoma quiz: every answer comes with an explanation and a link to the manual page.