Engine, Hybrid System

Air Injection Driver

~1min read
0102030405086N·mlb·ft
Tightening torque found on this page

Components

COMPONENTS

ILLUSTRATION

ILLUSTRATION

Disassembly

DISASSEMBLY

PROCEDURE

1. REMOVE AIR INJECTION CONTROL DRIVER (for Bank 1)

(a) Remove the 2 bolts.

(b) Remove the 2 screws and air injection control driver.

2. REMOVE AIR INJECTION CONTROL DRIVER (for Bank 2)

(a) Remove the 2 screws and air injection control driver.

Installation

INSTALLATION

PROCEDURE

1. INSTALL AIR INJECTION CONTROL DRIVER ASSEMBLY

(a) Install the air injection control driver with the 3 bolts.

Torque:

8 N·m {82 kgf·cm, 71 in·lbf}

(b) Connect the 2 wire harness clamps.

(c) Install the ground cable with the bolt.

Torque:

8 N·m {82 kgf·cm, 71 in·lbf}

(d) Connect the 4 air injection control driver connectors.

Reassembly

REASSEMBLY

PROCEDURE

1. INSTALL AIR INJECTION CONTROL DRIVER (for Bank 2)

(a) Install the air injection control driver with the 2 screws.

Torque:

2 N·m {20 kgf·cm, 18 in·lbf}

2. INSTALL AIR INJECTION CONTROL DRIVER (for Bank 1)

(a) Install the air injection control driver with the 2 screws.

Torque:

2 N·m {20 kgf·cm, 18 in·lbf}

(b) Install the 2 bolts.

Torque:

5 N·m {51 kgf·cm, 44 in·lbf}

Removal

REMOVAL

PROCEDURE

1. REMOVE AIR INJECTION CONTROL DRIVER ASSEMBLY

(a) Disconnect the 4 air injection control driver connectors.

(b) Remove the bolt and disconnect the ground cable.

(c) Disconnect the 2 wire harness clamps.

(d) Remove the 3 bolts and air injection control driver.