DISASSEMBLY
PROCEDURE
1. REMOVE GENERATOR PULLEY
SST: 09820-63011
09820-06010
09820-06021
SST 1-A and B |
09820-06010 |
SST 2 |
09820-06021 |
(a) Clamp the generator housing stay in a vise.
(b) Install SST 1-A to the pulley shaft.
(c) Install SST 1-B to SST 1-A.
(d) Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise to the specified torque.
Torque:
39 N·m {398 kgf·cm, 29 ft·lbf}
NOTICE:
Check that SST is secured on the rotor shaft.
(e) Insert SST 2, and attach the pulley nut to SST 2. |
 |
(f) To loosen the pulley nut, turn SST 1-A in the direction shown in the illustration.
NOTICE:
To prevent damage to the rotor shaft, do not loosen the pulley nut more than one-half turn. |
 |
(g) Remove SST 2 from the generator.
(h) Turn SST 1-B, and remove SST 1-A and B. |
 |
(i) Remove the pulley nut and pulley.
2. REMOVE GENERATOR REAR END COVER
(a) Place the generator on the pulley. |
 |
(b) Remove the 3 nuts and end cover.
(c) Remove the terminal insulator. |
 |
3. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY
(a) Remove the 2 screws and brush holder. |
 |
4. REMOVE GENERATOR COIL ASSEMBLY
(a) Remove the 4 bolts. |
 |
(b) Using SST, remove the coil assembly.
SST: 09950-40011
09951-04020
09952-04010
09953-04020
09954-04010
09955-04071
09957-04010
09958-04011 |
 |
(c) Remove the generator washer.
5. REMOVE GENERATOR ROTOR ASSEMBLY
6. REMOVE GENERATOR DRIVE END FRAME BEARING
(a) Remove the 4 screws and retainer plate. |
 |
(b) Using SST and a hammer, tap out the bearing.
SST: 09950-60010
09951-00250
SST: 09950-70010
09951-07100 |
 |
|