REASSEMBLY
PROCEDURE
1. REMOVE GENERATOR DRIVE END FRAME BEARING
(a) Using SST and a press, press in a new bearing.
SST: 09950-60010
09951-00470
SST: 09950-70010
09951-07100 |
 |
(b) Install the retainer plate with the 4 screws.
Torque:
2,3 N·m {23 kgf·cm, 20 in·lbf} |
 |
2. INSTALL GENERATOR ROTOR ASSEMBLY
(a) Place the drive end frame on the pulley. |
 |
(b) Install the rotor to the drive end frame.
3. INSTALL GENERATOR COIL ASSEMBLY
(a) Place the generator washer on the rotor. |
 |
(b) Using SST and a press, slowly press in the coil assembly.
SST: 09285-76010 |
 |
(c) Install the 4 bolts.
Torque:
5,8 N·m {59 kgf·cm, 51 in·lbf} |
 |
4. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY
(a) While pushing the 2 brushes toward the inside of the brush holder, insert a pin (diameter: 1.0 mm (0.0394 in.)) into the brush holder hole. |
 |
(b) Install the generator brush holder with the 2 screws.
Torque:
1,8 N·m {18 kgf·cm, 16 in·lbf} |
 |
(c) Pull out the pin from the generator brush holder.
5. INSTALL GENERATOR REAR END COVER
(a) Install the terminal insulator to the generator rectifier end frame.
NOTICE:
Pay attention to the mounting orientation of the terminal insulator. |
 |
(b) Install the end cover with the 3 nuts.
Torque:
4,6 N·m {47 kgf·cm, 41 in·lbf} |
 |
6. INSTALL GENERATOR PULLEY
SST: 09820-63011
09820-06010
09820-06021
SST 1-A and B |
09820-06010 |
SST 2 |
09820-06021 |
(a) Clamp the generator housing stay in a vise.
(b) Install SST 1-A to the pulley shaft.
(c) Install SST 1-B to SST 1-A.
(d) Install the pulley onto the rotor shaft by tightening the pulley nut by hand.
(e) Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise to the specified torque.
Torque:
39 N·m {398 kgf·cm, 29 ft·lbf}
NOTICE:
Check that SST is secured to the rotor shaft.
(f) Insert SST 2, and attach the pulley nut to SST 2. |
 |
(g) Tighten the pulley nut by turning SST 1-A in the direction shown in the illustration.
Torque:
133 N·m {1356 kgf·cm, 98 ft·lbf}
HINT:
Hold the adjustable wrench against the vise and tighten the nut securely. |
 |
(h) Remove SST 2 from the generator.
(i) Turn SST 1-B, and remove SST 1-A and B. |
 |
(j) Turn the pulley and check that the pulley moves smoothly. |