Vehicle Interior

Door Control Receiver(for Double Cab)

~2min read
0102030405075N·mlb·ft
Tightening torque found on this page

Components

COMPONENTS

ILLUSTRATION

*1

DOOR CONTROL AND TIRE PRESSURE MONITORING SYSTEM RECEIVER ASSEMBLY

-

-

N*m (kgf*cm, ft.*lbf): Specified torque

-

-

Installation

INSTALLATION

PROCEDURE

1. INSTALL DOOR CONTROL AND TIRE PRESSURE MONITORING SYSTEM RECEIVER ASSEMBLY

(a) Attach the 2 guides to install the door control and tire pressure monitoring system receiver assembly with the bolt.

Torque:

7 N·m {71 kgf·cm, 62 in·lbf}

NOTICE:

  • Avoid any impact to the door control and tire pressure monitoring system receiver assembly.
  • Do not drop the door control and tire pressure monitoring system receiver assembly. If it is dropped, replace it with a new one.

(b) Connect the connector.

2. INSTALL ROOF HEADLINING ASSEMBLY

Click here

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

4. REGISTRATION OF TRANSMITTER ID

Click here

5. INSPECT TIRE PRESSURE WARNING SYSTEM

Click here

6. PERFORM INITIALIZATION

Click here

Removal

REMOVAL

NOTICE:

  • It is necessary to perform initialization (See page ) after registration (See page ) of the transmitter IDs into the door control and tire pressure monitoring system receiver assembly after the receiver has been replaced.
  • When replacing the door control and tire pressure monitoring system receiver assembly, read the transmitter IDs stored in the old receiver using the intelligent tester or Techstream and write them down before removal.
  • After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

    Click here

PROCEDURE

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2. REMOVE ROOF HEADLINING ASSEMBLY

Click here

3. REMOVE DOOR CONTROL AND TIRE PRESSURE MONITORING SYSTEM RECEIVER ASSEMBLY

(a) Disconnect the connector.

(b) Remove the bolt.

(c) Detach the 2 guides and remove the door control and tire pressure monitoring system receiver assembly.

NOTICE:

  • Avoid any impact to the tire pressure warning ECU.
  • Do not drop the door control and tire pressure monitoring system receiver assembly. If it is dropped, replace it with a new one.