Vehicle Interior
Front Passenger Side Power Window Switch
Components
COMPONENTS
ILLUSTRATION
*1 |
FRONT UPPER ARMREST BASE PANEL RH |
*2 |
POWER WINDOW REGULATOR SWITCH ASSEMBLY |
Inspection
INSPECTION
PROCEDURE
1. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (w/o Jam Protection Function)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Switch Condition | Specified Condition |
4 (U) - 3 (B) |
UP |
Below 1 Ω |
1 (D) - 2 (SD) |
4 (U) - 5 (SU) |
OFF |
1 (D) - 2 (SD) |
4 (U) - 5 (SU) |
DOWN |
1 (D) - 3 (B) |
- If the result is not as specified, replace the power window regulator switch assembly. Text in Illustration
*a |
Component without harness connected
(Power Window Regulator Switch Assembly) |
2. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (w/ Jam Protection Function)
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Switch Condition | Specified Condition |
1 (GND) - 6 (UP) |
AUTO UP |
Below 1 Ω |
1 (GND) - 8 (AUTO) |
4 (LED) - 7 (DOWN) |
1 (GND) - 6 (UP) |
MANUAL UP |
1 (GND) - 7 (DOWN) |
MANUAL DOWN |
4 (LED) - 6 (UP) |
OFF |
4 (LED) - 7 (DOWN) |
1 (GND) - 7 (DOWN) |
AUTO DOWN |
1 (GND) - 8 (AUTO) |
4 (LED) - 6 (UP) |
- If the result is not as specified, replace the power window regulator switch assembly. Text in Illustration
*a |
Component without harness connected
(Power Window Regulator Switch Assembly) |
Installation
INSTALLATION
PROCEDURE
1. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY
(a) Attach the 2 claws to install the power window regulator switch assembly.
2. INSTALL FRONT UPPER ARMREST BASE PANEL RH
(a) Connect the 2 connectors.
(b) Attach the 2 clips and 5 claws to install the front upper armrest base panel RH. |
 |
Removal
REMOVAL
PROCEDURE
1. REMOVE FRONT UPPER ARMREST BASE PANEL RH
(a) Using a moulding remover A, detach the 2 clips and 5 claws, and remove the front upper armrest base panel RH. |
 |
(b) Disconnect the 2 connectors. |
 |
2. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY
(a) Detach the 2 claws and remove the power window regulator switch assembly. |
 |
|
Was this page helpful?