Vehicle Interior
IG Power Source Circuit
DESCRIPTION
When the ignition switch is turned ON, positive (+) battery voltage is applied to the air conditioning amplifier.
WIRING DIAGRAM
PROCEDURE
INSPECT FUSE (ECU-IG1 NO.3)
(a) Remove the ECU-IG1 NO.3 fuse from the driver side junction block.
(b) Measure the resistance according to the value(s) in the table below.
Standard resistance:
Tester Connection | Condition | Specified Condition |
ECU-IG1 NO.3 fuse |
Always |
Below 1 Ω |
| NG |
 |
REPLACE FUSE |
| OK |
 |
|
CHECK HARNESS AND CONNECTOR (AIR CONDITIONING AMPLIFIER - BATTERY AND BODY GROUND)
(a) Disconnect the J19 air conditioning amplifier connector.
(b) Measure the resistance and voltage according to the value(s) in the table below.
Standard resistance:
Tester Connection | Condition | Specified Condition |
J19-14 (GND) - Body ground |
Always |
Below 1 Ω |
Standard voltage:
Tester Connection | Switch Condition | Specified Condition |
J19-1 (IG+) - Body ground |
Ignition switch ON |
11 to 14 V |
| OK |
 |
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG |
 |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
Was this page helpful?