(a) Inspect the A.D.D. actuator (differential vacuum actuator assembly).
(1) Remove the A.D.D. actuator (differential vacuum actuator assembly) (See page ).
(2) Check the Free to Lock switch. Connect lines via a relay as shown in the illustration, then check that the differential vacuum actuator assembly fork moves from the Free to Lock position.
NOTICE:
Make sure to perform this inspection with the differential vacuum actuator assembly removed from the vehicle. If this inspection is performed with the differential vacuum actuator assembly installed to the vehicle, the differential vacuum actuator assembly will be damaged.
When inspecting the differential vacuum actuator assembly, make sure to operate it with the lines connected via a relay. If the lines are not connected via a relay and battery voltage is directly applied to the differential vacuum actuator assembly, the differential vacuum actuator assembly will be damaged.
HINT:
When inspecting the operation described above, use the BACK P/W NO. 2 relay.
After the Free to Lock switch is complete, inspect the A.D.D. (differential vacuum actuator assembly) detection switch and limit switch.
Standard resistance:
Tester Connection
Condition
Condition
3 (ADD) - 4 (GND)
After Free to Lock switch is complete
Below 1 Ω
5 (DL2) - 4 (GND)
After Free to Lock switch is complete
100 kΩ or higher
6 (DL1) - 4 (GND)
After Free to Lock switch is complete
Below 1 Ω
(3) Check the Lock to Free switch. Connect lines via a relay as shown in the illustration, then check that the differential vacuum actuator assembly fork moves from the Lock to Free position.
After the Lock to Free switch is complete, inspect the A.D.D. (differential vacuum actuator assembly) detection switch and limit switch.
Standard resistance:
Tester Connection
Condition
Condition
3 (ADD) - 4 (GND)
After Lock to Free switch is complete
100 kΩ or higher
5 (DL2) - 4 (GND)
After Lock to Free switch is complete
Below 1 Ω
6 (DL1) - 4 (GND)
After Lock to Free switch is complete
100 kΩ or higher
If there is a malfunction, replace the A.D.D. actuator (differential vacuum actuator assembly) (See page ). If the A.D.D. actuator (differential vacuum actuator assembly) is normal, replace the 4WD control ECU (See page ).