Audio, Visual, Telematics

Inspection

~1min read

INSPECTION

PROCEDURE

1. INSPECT BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Switch Condition

Specified Condition

7 (IG) - 8 (SK)

Sonar switch off

10 kΩ or higher

Sonar switch on

Below 1 Ω

If the result is not as specified, replace the back sonar or clearance sonar switch assembly.

(b) Check that the switch illuminates.

OK:

Tester Connection

Specified Condition

Battery positive (+) → Terminal 1 (ILL+)

Battery negative (-) → Terminal 6 (ILL-)

Illuminates

If the result is not as specified, replace the back sonar or clearance sonar switch assembly.

Text in Illustration

*a

Component without harness connected

(Back Sonar or Clearance Sonar Switch Assembly)