INSPECTION
PROCEDURE
1. INSPECT TRAILER BRAKE CONTROL SWITCH
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection | Switch Condition | Specified Condition |
8 (SRF) -5 (SRRT) |
- |
2 kΩ to 3.09 kΩ |
8 (SRF) -16 (SRW1) |
Manual trailer brake output slider operated to maximum position (100%) |
Below 1 kΩ |
Manual trailer brake output slider not operated (0%) |
2 kΩ to 3 kΩ |
8 (SRF) -14 (SRW2) |
Manual trailer brake output slider operated to maximum position (100%) |
2 kΩ to 3 kΩ |
Manual trailer brake output slider not operated (0%) |
Below 1 kΩ |
8 (SRF) -15 (SRR) |
- |
12 Ω to 14 Ω |
4 (GA+) -6 (GND) |
GAIN (+) selection button pressed |
Below 20 Ω |
GAIN (+) selection button not pressed |
100 kΩ or higher |
4 (GA-) -6 (GND) |
GAIN (-) selection button pressed |
Below 20 Ω |
GAIN (-) selection button not pressed |
100 kΩ or higher |
If the result is not as specified, replace the trailer brake control switch. |
 |
*a |
Component without harness connected
(Trailer brake control switch) |
*b |
GAIN (+) selection button |
*c |
GAIN (-) selection button |
*d |
Manual trailer brake output slider |
|
|
(b) Check that the LED illuminates.
(1) Apply battery voltage between the terminals of the trailer brake control switch, and check the illumination condition.
OK:
Measurement Condition | Switch Condition |
Battery positive (+) →3 (TAIL)
Battery negative (-) → 1 (ILL-) |
Illuminates |
If the result is not as specified, replace the trailer brake control switch. |
 |
*a |
Component without harness connected
(Trailer brake control switch) |
*b |
Indicator |
|
|
|
Was this page helpful?