Engine, Hybrid System
Installation
In this manual: Engine, Hybrid System
~1min read
INSTALLATION
PROCEDURE
1. INSTALL STARTER ASSEMBLY
(a) Install the flywheel housing side cover.
(b) Install the starter with the 2 bolts.
Torque:
37 N·m {377 kgf·cm, 27 ft·lbf}
(c) Connect the starter wire with the nut.
Torque:
9,8 N·m {100 kgf·cm, 87 in·lbf}
(d) Connect the starter connector.
(e) Attach the 2 wire harness clamps.
2. INSTALL STARTER COVER
(a) Install the starter cover with the 3 bolts.
Torque:
12 N·m {117 kgf·cm, 8 ft·lbf}
3. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY RH
(See page
)
4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
Was this page helpful?