Brake

On-vehicle Inspection

~1min read

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT BRAKE PEDAL LOAD SENSING SWITCH

HINT:

  • Do not remove the brake pedal load sensing switch from the brake pedal support assembly.
  • When there is a malfunction in the brake pedal load sensing switch, replace the brake pedal support assembly.

(a) Disconnect the brake pedal load sensing switch connector.

Text in Illustration

*1

Brake Pedal Load Sensing Switch

-

-

*a

Brake pedal released (ON)

*b

Brake pedal depressed (OFF)

(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

2 (FSW+) - 1 (FSW-)

Brake pedal depressed

900 to 1100 Ω

Brake pedal released

192 to 234 Ω