Rear Crankshaft Oil Seal
ComponentsCOMPONENTSILLUSTRATION
InstallationINSTALLATIONPROCEDURE1. INSTALL REAR CRANKSHAFT OIL SEAL (a) Apply MP grease to the lip of a new oil seal.
2. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY 3. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (a) for 2WD: Refer to the following procedures (See page (b) for 4WD: Refer to the following procedures (See page 4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL RemovalREMOVALPROCEDURE1. PRECAUTION NOTICE: After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (See page 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 3. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (a) for 2WD: Refer to the following procedures (See page (b) for 4WD: Refer to the following procedures (See page 4. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY 5. REMOVE REAR CRANKSHAFT OIL SEAL (a) Using a knife, cut off the lip of the oil seal.
|





