Engine, Hybrid System

Removal

~1min read

REMOVAL

PROCEDURE

1. REMOVE V-BANK COVER SUB-ASSEMBLY

2. REMOVE NO. 1 ENGINE UNDER COVER

3. DRAIN ENGINE COOLANT

4. REMOVE INLET RADIATOR HOSE

5. REMOVE FAN AND GENERATOR V BELT

6. REMOVE FAN SHROUD

7. DISCONNECT FRONT STABILIZER BAR

(a) Remove the 4 bolts, 2 stabilizer brackets and 2 stabilizer bushes. Then disconnect the stabilizer bar.

8. DISCONNECT COOLER COMPRESSOR ASSEMBLY

9. REMOVE OIL PRESSURE SENDER GAUGE ASSEMBLY

10. REMOVE OIL FILTER BRACKET

11. REMOVE CRANKSHAFT PULLEY

12. REMOVE CRANKSHAFT TIMING GEAR KEY

(a) Remove the crankshaft timing gear key from the crankshaft.

13. REMOVE FRONT CRANKSHAFT OIL SEAL

(a) Using a screwdriver, pry out the oil seal.

NOTICE:

Do not damage the surface of the oil seal press fit hole and crankshaft.

HINT:

Tape the screwdriver tip before use.