Vehicle Interior
Rear Door Belt Moulding(for Double Cab)
In this manual: Vehicle Interior
~1min read
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
PROCEDURE
1. INSTALL REAR OUTER DOOR GLASS WEATHERSTRIP LH
(a) Attach the claw to install the weatherstrip.
2. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

3. INSTALL REAR DOOR ARMREST COVER LH
4. INSTALL REAR DOOR FRAME GARNISH LH

5. INSTALL REAR UPPER DOOR ARMREST BASE PANEL LH

6. INSTALL REAR DOOR INSIDE HANDLE BEZEL PLUG LH

Removal
REMOVAL
HINT:
- Use the same procedures for the RH side and LH side.
- The procedures listed below are for the LH side.
PROCEDURE
1. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH

2. REMOVE REAR UPPER DOOR ARMREST BASE PANEL LH

3. REMOVE REAR DOOR FRAME GARNISH LH

4. REMOVE REAR DOOR ARMREST COVER LH
5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH

6. REMOVE REAR OUTER DOOR GLASS WEATHERSTRIP LH
(a) Put protective tape around the weatherstrip outer.
(b) Using a moulding remover, detach the claw and remove the weatherstrip.
Was this page helpful?