Engine, Hybrid System
Reassembly
REASSEMBLY
PROCEDURE
1. INSTALL FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING
(a) Apply MP grease to a new spider and bearings.
NOTICE:
Be careful not to apply too much grease.
(b) Fit the spider to the yoke.
(c) Measure dimension A between the snap ring grooves. |
 |
(d) Insert the spider bearing into the spider journal portion, and then measure dimension B of the universal joint.
NOTICE:
When measuring dimension B, fix the spider and needle roller bearings in a vise and hold them firmly together.
(e) Select snap rings to make dimensions A and B the same.
Hole Snap Ring Thickness:
Color | Thickness |
Black |
1.486 mm (0.0585 in.) |
Copper |
1.511 mm (0.0595 in.) |
White |
1.537 mm (0.0605 in.) |
Yellow |
1.588 mm (0.0625 in.) |
Blue |
1.638 mm (0.0645 in.) |
NOTICE:
- Use new snap rings.
- If possible, use snap rings of the same thickness for both edges.
|
 |
(f) Insert the spider into the flange yoke, and then using SST, press in the spider bearing into the snap ring groove.
SST: 09332-25010
HINT:
Press in the spider bearing on the opposite side in the same way.
NOTICE:
When pressing in the spider bearing, be careful not to damage its lip. |
 |
(g) Using needle-nose pliers, install new snap rings into the grooves of the yoke. |
 |
2. INSPECT FRONT PROPELLER SHAFT UNIVERSAL JOINT SPIDER BEARING
3. INSPECT FRONT PROPELLER SHAFT ASSEMBLY
HINT:
When replacing the spider bearing, make sure that the grease fitting assembly hole is facing in the direction shown in the illustration. Text in Illustration
 |
Rear Side |
- |
- |
|
Was this page helpful?