Toyota Venza Quiz
Brake Control / Dynamic Control Systems

Brake Pedal Load Sensing Switch

In this manual: Brake Control / Dynamic Control Systems
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE

1. INSPECT BRAKE PEDAL LOAD SENSING SWITCH

NOTICE:

  • Do not remove the brake pedal load sensing switch from the brake pedal support assembly.
  • When there is a malfunction in the brake pedal load sensing switch, replace the brake pedal support assembly.

(a) Disconnect the brake pedal load sensing switch connector.


(b) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

2 (FSW+) - 1 (GND)

Brake pedal load sensing switch OFF (Brake pedal depressed)

950 to 1050 Ω

2 (FSW+) - 1 (GND)

Brake pedal load sensing switch ON (Brake pedal released)

203 to 223 Ω

If the value is not as specified, replace the brake pedal support assembly (See page ).

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.