Checking and replacing fuses

If any of the electrical components do not operate, a fuse may have blown. If this happens, check and replace the fuses as necessary.

Vehicles with smart key system:

Turn the “ENGINE START STOP” switch off.

Vehicles without smart key system:

Turn the engine switch to the “LOCK” position.

Open the fuse box cover.

► Engine compartment

Push the tab in and lift the lid off.

► Driver’s side instrument panel

Remove the lid.

After a system failure, see “Fuse
layout and amperage ratings” for details about which fuse to check.

Remove the fuse with the pullout tool.

Check if the fuse has blown.

►Type A

1. Normal fuse
2. Blown fuse

Replace it with one of an appropriate amperage rating.

The amperage rating can be found on the fuse box lid.

►Type B

1. Normal fuse
2. Blown fuse

Contact your Toyota dealer.

Fuse layout and amperage ratings - Engine compartment

►Fuse block

►Back of the cover

- Driver’s side instrument panel

- After a fuse is replaced • If the lights do not turn on even after the fuse has been replaced, a bulb may need replacement.
• If the replaced fuse blows again, have the vehicle inspected by your Toyota dealer. - If there is an overload in the circuits

The fuses are designed to blow, protecting the wiring harness from damage.

CAUTION - To prevent system breakdowns and vehicle fire Observe the following precautions. Failing to do so may cause damage to the vehicle, and possibly a fire or injury. • Never use a fuse of a higher amperage rating than indicated, or use any other object in place of a fuse. • Always use a genuine Toyota fuse or equivalent. Never replace a fuse with a wire, even as a temporary fix.

• Do not modify fuses or the fuse box.

NOTICE
- Before replacing fuses

Have the cause of electrical overload determined and repaired by your Toyota dealer.