Toyota Venza Quiz
Meter / Gauge / Display

Combination Meter

In this manual: Meter / Gauge / Display
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
Components COMPONENTS ILLUSTRATION
Disassembly DISASSEMBLY PROCEDURE

1. REMOVE COMBINATION METER GLASS

(a) Disengage the 9 claws to remove the combination meter glass.
Removal REMOVAL PROCEDURE

1. REMOVE LOWER STEERING COLUMN COVER


2. REMOVE UPPER STEERING COLUMN COVER


3. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).


4. REMOVE INSTRUMENT CLUSTER FINISH PANEL

(a) Remove the 2 clips.

(b) Disengage the 3 claws and remove the instrument cluster finish panel.

5. REMOVE COMBINATION METER ASSEMBLY

(a) Remove the 4 screws.

(b) Disconnect the connectors and remove the combination meter assembly.

Reassembly REASSEMBLY PROCEDURE

1. INSTALL COMBINATION METER GLASS

(a) Engage the 9 claws to install the combination meter glass.
Installation INSTALLATION PROCEDURE

1. INSTALL COMBINATION METER ASSEMBLY

(a) Connect the connectors.

(b) Install the combination meter assembly with the 4 screws.

2. INSTALL INSTRUMENT CLUSTER FINISH PANEL

(a) Engage the 3 claws.

(b) Install the instrument cluster finish panel with the 2 clips.

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).


4. INSTALL UPPER STEERING COLUMN COVER


5. INSTALL LOWER STEERING COLUMN COVER

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.