Toyota Venza Quiz
1ar-fe Starting

Ignition Switch

In this manual: 1ar-fe Starting
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
Components COMPONENTS ILLUSTRATION
Removal REMOVAL PROCEDURE

1. REMOVE LOWER STEERING COLUMN COVER


2. REMOVE UPPER STEERING COLUMN COVER


3. REMOVE IGNITION SWITCH

(a) Remove the 2 screws and ignition switch.

(b) Disconnect the connector.

(c) Disconnect the connector clamp from the ignition switch.

Inspection INSPECTION PROCEDURE

1. INSPECT IGNITION SWITCH

(a) Measure the switch resistance.

Standard Resistance:

Tester Connection

Switch Position

Specified Condition

Between all terminals

LOCK

10 kΩ or higher

2 (AM1) - 3 (ACC)

ACC

Below 1 Ω

2 (AM1) - 3 (ACC)

ON

2 (AM1) - 4 (IG1)

6 (IG2) - 7 (AM2)

1 (ST1) - 2 (AM1)

START

2 (AM1) - 4 (IG1)

6 (IG2) - 7 (AM2)

7 (AM2) - 8 (ST2)

If the result is not as specified, replace the switch assembly.
Installation INSTALLATION PROCEDURE

1. INSTALL IGNITION SWITCH

(a) Connect the connector.

(b) Install the connector clamp to the ignition switch.

(c) Install the ignition switch with the 2 screws.

2. INSTALL UPPER STEERING COLUMN COVER


3. INSTALL LOWER STEERING COLUMN COVER

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.