Installation

1. INSTALL STEERING PAD

(a) Check that the ignition switch is off.

(b) Check that the cable is disconnected from the negative (-) battery terminal.

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

(c) Connect the 2 airbag connectors to the steering pad. Text in Illustration *1 Airbag Connector *2 Horn Connector *3 Airbag Connector Lock NOTICE: When connecting any airbag connector, take care not to damage the airbag wire harness. Be sure to only connect the connectors to each corresponding color.

(d) Push in the 2 airbag connector locks to install the 2 airbag connectors.

(e) Connect the horn connector to the steering pad.

(f) Push the steering pad to engage the 3 pins carefully. NOTICE: Make sure that the pins are securely inserted into the steering holes. Make sure to engage the 2 upper pins first. Make sure that the steering pad is securely installed.

2. INSTALL LOWER NO. 3 STEERING WHEEL COVER

(a) Engage the claw and guide to install the lower No. 3 steering wheel cover.

3. INSTALL LOWER NO. 2 STEERING WHEEL COVER

(a) Engage the claw and guide to install the lower No. 2 steering wheel cover.

4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

5. INSPECT STEERING PAD

(a) Make sure that the horn sounds.

HINT:

If the horn does not sound, inspect the horn system (See page ).

6. PERFORM DIAGNOSTIC SYSTEM CHECK

(See page )

7. INSPECT SRS WARNING LIGHT

(See page )