Toyota Venza Quiz
Mirror (ext)

Outer Mirror Control Ecu

In this manual: Mirror (ext)
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
Components COMPONENTS ILLUSTRATION
Removal REMOVAL PROCEDURE

1. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG


2. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)


3. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)


4. REMOVE COURTESY LIGHT ASSEMBLY


5. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY


6. REMOVE FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY


7. REMOVE OUTER MIRROR CONTROL ECU ASSEMBLY

(a) Disconnect the 2 connectors.

(b) Remove the 2 screws and outer mirror control ECU assembly.
Installation INSTALLATION PROCEDURE

1. INSTALL OUTER MIRROR CONTROL ECU ASSEMBLY

(a) Install the outer mirror control ECU assembly with the 2 screws.

(b) Connect the 2 connectors.

2. INSTALL FRONT DOOR INSIDE HANDLE SUB-ASSEMBLY


3. INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY


4. INSTALL COURTESY LIGHT ASSEMBLY


5. INSTALL POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Driver Side)


6. INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL (for Front Passenger Side)


7. INSTALL FRONT DOOR INSIDE HANDLE BEZEL PLUG

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.