Toyota Venza Quiz
1ar-fe Fuel

Reassembly

In this manual: 1ar-fe Fuel
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
REASSEMBLY PROCEDURE

1. INSTALL FUEL PUMP ASSEMBLY WITH FILTER

HINT:

Perform "Inspection After Repair" after replacing the fuel pump (See page ).


(a) Apply gasoline to a new O-ring. Then install the O-ring and spacer to the fuel pump.

Text in Illustration

*1

O-ring

*2

Spacer

(b) Engage the 5 claws on the fuel filter and install the fuel pump assembly with filter.

NOTICE:

  • Make sure the O-ring is not cut or pinched during the installation.
  • Attach the claws securely.

2. INSTALL FUEL FILTER ASSEMBLY

(a) Apply gasoline to a new O-ring and install it to the jet pump.

Text in Illustration

*1

Jet Pump

*2

O-ring

(b) Install the jet pump to the sub-tank as shown in the illustration.

(c) Connect the jet pump nozzle to the fuel sub-tank.

(d) Install the fuel filter to the sub-tank and attach the 2 claws.

(e) Connect the fuel pump connector to the fuel pump.

3. INSTALL FUEL SUCTION PLATE SUB-ASSEMBLY

(a) Install the spring to the fuel suction plate shaft.

(b) Install the fuel suction plate to the sub-tank.

(c) Install a new E-ring.

Text in Illustration

*1

E-ring

(d) Connect the fuel pump connector to the fuel suction plate.

4. INSTALL FUEL SENDER GAUGE

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.