Horn
Relay
In this manual: Horn
~1min read
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE
Text in Illustration
1. INSPECT HORN RELAY (ENGINE ROOM JUNCTION BLOCK ASSEMBLY)
(a) Remove the engine room junction block assembly from the engine room relay block (See page |
![]() |
(b) Connect a positive (+) lead from the battery to terminal 1A-1.
(c) Connect a negative (-) lead from the battery to terminal 1F-7.
(d) Measure the voltage according to the value(s) in the table below.
Standard Voltage:
Tester Connection | Condition | Specified Condition |
|---|---|---|
1E-3 - Battery negative |
Always |
11 to 14 V |
*1 |
Component without harness connected (Engine Room Junction Block Assembly) |
If the result is not as specified, replace the engine room junction block assembly.
Test yourself
A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.
Was this page helpful?
).