Toyota Venza Quiz
Window / Glass

Relay

In this manual: Window / Glass
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
On-vehicle Inspection ON-VEHICLE INSPECTION PROCEDURE

1. INSPECT RR DEF RELAY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

3 - 4

Battery voltage applied between terminals 1 and 2

10 kΩ or higher

3 - 4

Battery voltage not applied between terminals 1 and 2

Below 1 Ω

3 - 5

Battery voltage applied between terminals 1 and 2

Below 1 Ω

3 - 5

Battery voltage not applied between terminals 1 and 2

10 kΩ or higher

If the result is not as specified, replace the DEF relay.

2. INSPECT DEICER RELAY

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

3 - 5

Battery voltage applied to terminals 1 and 2

Below 1 Ω

3 - 5

Battery voltage not applied between terminals 1 and 2

10 kΩ or higher

If the result is not as specified, replace the DEICER relay.

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.