Removal

NOTICE:

• Do not replace the spiral cable with the battery connected and the ignition switch ON.
• Do not rotate the spiral cable without the steering wheel with the battery connected and the ignition switch ON.
• Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

1. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD

2. REMOVE STEERING PAD

(See page )

3. REMOVE STEERING WHEEL ASSEMBLY

(a) Remove the steering wheel assembly set nut. Text in Illustration *1 Matchmark

(b) Put matchmarks on the steering wheel assembly and the steering main shaft.

(c) Disconnect each connector from the spiral cable sub-assembly.

(d) Using SST, remove the steering wheel assembly. Text in Illustration *1 Turn *2 Hold SST: 09950-50013 09951-05010 09952-05010 09953-05020 09954-05070 NOTICE: Apply a small amount of grease to the threads and tip of SST (09953-05020) before use. Do not rotate the spiral cable with the battery connected and the ignition switch ON. Ensure that the steering wheel is installed and aligned straight when inspecting the steering sensor.

4. REMOVE STEERING PAD SWITCH ASSEMBLY

(a) Remove the 2 screws. Text in Illustration *1 Pin *2 Guide

(b) Disengage the 2 claws, 2 pins and 2 guides to remove the steering pad switch assembly.

5. REMOVE CRUISE CONTROL MAIN SWITCH

6. REMOVE CRUISE CONTROL SWITCH WIRE

7. REMOVE STEERING SHAKE DAMPER

(a) Remove the 2 screws and steering shake damper from the steering wheel sub-assembly.