Removal

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2. REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG

3. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

4. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

5. REMOVE REAR DOOR INSIDE HANDLE SUB-ASSEMBLY

6. REMOVE REAR DOOR SERVICE HOLE COVER

7. REMOVE REAR DOOR CHECK ASSEMBLY

8. REMOVE REAR DOOR WEATHERSTRIP

9. REMOVE REAR DOOR GLASS RUN

10. REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY

11. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

12. REMOVE REAR DOOR BELT MOULDING

(a) Put protective tape around the rear door belt moulding. Text in Illustration *1 Protective Tape

(b) Using a screwdriver, disengage the 5 claws and remove the rear door belt moulding.