Toyota Venza Quiz
Mirror (int)

Removal

In this manual: Mirror (int)
Introduction — 15Maintenance — 8Audio / Video — 102Garage Door Opener — 8Navigation / Multi Info Display — 81Park Assist / Monitoring — 50Brake (front) — 7Brake (rear) — 7Brake Control / Dynamic Control Systems — 79Brake System (other) — 28Parking Brake — 22Axle And Differential — 44Drive Shaft / Propeller Shaft — 24Mf1a Transfer / 4wd / Awd — 46U660e Automatic Transmission / Transaxle — 1241ar-fe Cooling — 311ar-fe Emission Control — 101ar-fe Engine Control — 1331ar-fe Engine Mechanical — 441ar-fe Fuel — 311ar-fe Intake / Exhaust — 211ar-fe Lubrication — 111ar-fe Starting — 16Cruise Control — 241ar-fe Battery / Charging — 162gr-fe Battery / Charging — 17Networking — 67Power Distribution — 8Power Assist Systems — 34Steering Column — 37Steering Gear / Linkage — 29Alignment / Handling Diagnosis — 4Front Suspension — 39Rear Suspension — 35Tire / Wheel — 4Tire Pressure Monitoring — 35Door / Hatch — 83Exterior Panels / Trim — 56Horn — 4Lighting (ext) — 89Mirror (ext) — 36Sliding Roof / Convertible — 26Window / Glass — 87Wiper / Washer — 30Door Lock — 85Heating / Air Conditioning — 82Interior Panels / Trim — 20Lighting (int) — 37Meter / Gauge / Display — 41Mirror (int) — 9Power Outlets (int) — 10Seat — 84Seat Belt — 43Supplemental Restraint Systems — 131Theft Deterrent / Keyless Entry — 155
~1min read
REMOVAL PROCEDURE

1. REMOVE INNER REAR VIEW MIRROR STAY HOLDER COVER

(a) Disengage the 2 claws and slide the inner rear view mirror stay holder cover as shown in the illustration.

(b) Disengage the 2 claws and remove the inner rear view mirror stay holder cover.

2. REMOVE INNER REAR VIEW MIRROR ASSEMBLY (w/o Automatic High Beam System)

(a) Disconnect the connector.

(b) Using a T20 "TORX" socket wrench, remove the screw and the inner rear view mirror assembly.

3. REMOVE INNER REAR VIEW MIRROR ASSEMBLY (w/ Automatic High Beam System)

NOTICE:

  • Do not touch of the camera lens (built into the inner rear view mirror assembly) with a bare hand.
  • Do not allow anything to adhere to the camera lens (built into the inner rear view mirror assembly).
  • Do not apply strong impact to the inner rear view mirror assembly.
  • Do not allow any liquids to get on the inner rear view mirror assembly.

(a) Disconnect the connector.

(b) Using a T20 "TORX" socket wrench, remove the screw and the inner rear view mirror assembly.

Test yourself

A quick Toyota Venza quiz: every answer comes with an explanation and a link to the manual page.