Removal

1. PRECAUTION

(See page )

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work (See page ).

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

3. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)

4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)

5. REMOVE NO. 2 CONSOLE BOX CARPET

6. REMOVE CONSOLE BOX ASSEMBLY

7. REMOVE AIR CONDITIONING CONTROL ASSEMBLY

8. REMOVE FRONT DOOR SCUFF PLATE RH

9. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

10. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

11. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

12. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

13. REMOVE POSITION INDICATOR HOUSING ASSEMBLY

14. REMOVE CONSOLE BOX SUB-ASSEMBLY

15. REMOVE NO. 2 INSTRUMENT PANEL SPEAKER PANEL SUB-ASSEMBLY

16. REMOVE NAVIGATION RECEIVER ASSEMBLY WITH BRACKET

(a) Remove the 4 bolts.

(b) Disengage the 2 clips.

(c) Disconnect each connector and remove the navigation receiver assembly with bracket.

17. REMOVE INSTRUMENT CLUSTER CENTER FINISH PANEL SUB-ASSEMBLY

(a) Remove the 4 screws.

(b) Disengage the 4 claws and remove the instrument cluster center finish panel sub-assembly.

18. REMOVE STEREO COMPONENT TUNER ASSEMBLY WITH WIRE (w/ Satellite Radio)

19. REMOVE NO. 1 RADIO RECEIVER BRACKET

(a) Remove the 4 screws and No. 1 radio receiver bracket.

20. REMOVE NO. 2 RADIO RECEIVER BRACKET

(a) Remove the 4 screws and No. 2 radio receiver bracket.

21. REMOVE NAVIGATION RECEIVER ASSEMBLY