Removal

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected (See page ).

2. REMOVE FRONT SEAT ASSEMBLY LH

HINT:

Refer to the instructions for Removal of the front seat assembly.

• for Manual Seat: See page


• for Power Seat: See page

3. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/o Seat Heater System)

4. REMOVE UPPER CONSOLE PANEL SUB-ASSEMBLY (w/ Seat Heater System)

5. REMOVE NO. 2 CONSOLE BOX CARPET

6. REMOVE CONSOLE BOX ASSEMBLY

7. REMOVE AIR CONDITIONING CONTROL ASSEMBLY

8. REMOVE FRONT DOOR SCUFF PLATE LH

9. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

10. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

11. REMOVE FRONT DOOR SCUFF PLATE RH

12. REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH

13. REMOVE NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

14. REMOVE LOWER INSTRUMENT PANEL SUB-ASSEMBLY

15. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY

16. REMOVE POSITION INDICATOR HOUSING ASSEMBLY

17. REMOVE CONSOLE BOX SUB-ASSEMBLY

18. SEPARATE PARKING BRAKE PEDAL ASSEMBLY

(a) Turn back the floor carpet.

(b) Disconnect the heated oxygen sensor connector and disengage the 2 clamps (for 2GR-FE).

(c) Remove the bolt and nut, and separate the No. 1 parking brake cable assembly from the body.

(d) Disconnect the parking brake switch connector.

(e) Remove the 3 nuts and separate the parking brake pedal assembly from the body.

19. REMOVE PARKING BRAKE SWITCH ASSEMBLY

(a) Remove the screw and parking brake switch assembly.